Weidmuller Crimpfix L Originalbetriebsanleitung Seite 36

Setting up the machine
Adjusting the stripping length on the release device
Figure 5.4 Release device adjustment (set: B)
You can vary the stripping length using the setting.
► Press the adjusting wheel backwards and turn it so
that the required value is at the marked position (see
figure 5.4).
► Release the adjusting wheel so that it latches in.
You can perform fine adjustments within the selected con-
figuration range (A, B or C):
► To increase the stripping length, turn toward "+";
to reduce the stripping length, turn toward "–".
Configuring the wire insertion unit
Figure 5.5 Wire-insertion unit configuration (set: B)
► Pull the tool unit forwards and set the lever to the re-
quired value.
36
Adjusting the opening wedge
The opening wedge is only adjustable if the
stranded wire fixing unit is in the operating posi-
tion (see section 7.7).
1
Figure 5.6 Adjusting the opening wedge
► Release the fixing screw (1) until the adjustment plate
can be moved and the catch pins (2) are free.
► Bring the adjustment plate into the required position (3).
In this process, one of the catch pins must fit into an
opening.
► Re-apply the fixing screws.
3
2
2518100000/03/06.2017