Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Tools Required
Preparation
before Assembly
IMPORTANT
Assembly
Ref.
1
2
3
4
5
6
7
8
9
Note:
It is recommended to connect cables by soldering. This will ensure a safe
connection and help to avoid damages!
1
Park the vehicle in a safe spot by applying parking brake and remove the
ignition key.
2
Be sure not to damage any vehicle parts.
Check that all the parts are contained in the kit as shown in "Contents"
3
section.
WARNING / CAUTION / NOTICE:
Please read this manual and follow its instruction carefully. To
emphasize special information, the symbol and the words
WARNING, CAUTION and NOTICE have special meanings.
Pay special attention to the messages highlighted by these
signal words!
1.
Remove the bottom panel on the driver side under the steering
mast according to instructions of the car repair manual.
2.
Choose the place for installation of the relay socket with cable
kit l
Fix the rain sensor k at the windscreen within the wiping
3.
area (Fig.1). The LED on the rear side of the sensor is a
control light. Take into consideration that the windscreen
must be dirt-and fat-free in the place of pasting! Use the
cleaning cloth for this purpose. Don't paste the sensor in the
lacquered or tinted area of the windscreen. This can cause
malfunctions! Remove the protective layer and press the
sensor to the screen. There must be no air between the
sensor and the windscreen on the adhesive pad.
Tools Description
Cross point screwdriver
Cable tie
Pliers
Side cutter
Window cleander / wiper
Cloth
Soldering tool and soldering tin
(recommended)
Adhesive tape
Car specific repair manual
SUZUKI GENUINE ACCESSORIES 2018-08-01
3
WARNING
Indicates a potential
hazard that could result in
death or
serious injury.
CAUTION
Indicates a potential
hazard that could result in
minor or
moderate injury.
Fig.1
Fig. 1a
Werbung
