Setup; Assembling And Unfolding The Handle - Toro 53cm Super Recycler 20792 Bedienungsanleitung

Setup

Important:
Remove and discard the protective
plastic sheet that covers the engine and any other
plastic or wrapping on the machine.
Important:
To prevent accidental starting,
do not insert the electric-start button into the
electric-start ignition until you are ready to start
the engine (electric-start model only).
1
Assembling and Unfolding
the Handle
No Parts Required
Procedure
WARNING

Assembling and unfolding the handle

improperly can damage the cables, causing
an unsafe operating condition.
• Do not damage the cables when
assembling and unfolding the handle.
• Ensure that the cables are routed to the
outside of the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1. Raise the rear of the machine housing to its
highest cutting-height setting by moving the 2
rear cutting-height levers all the way forward.
Refer to Adjusting the Cutting Height (page
2. Attach the handle ends to the machine housing
with 2 washers and 2 handle bolts
but do not tighten the handle bolts.
1. Washer
2. Handle bolt
Important:
of the handle.
3. Rotate the handle rearward
11).
(Figure 3),
6
Figure 3
3. Handle end
Route the cables to the outside
(Figure
Figure 4
g187513
4).
g187600