2.
Lift open the side-discharge door
Figure 30
3.
Install the side-discharge chute and close the
door onto the chute
Figure 31
Removing the Side-Discharge Chute
To remove the side discharge chute, reverse the steps
above.
Important:
Lock the side-discharge door after
you close it
(Figure
32).
Figure 32
Rear-Discharging the Clippings
If the bag is on the machine, remove it; refer to
Removing the Grass Bag (page
If the side discharge chute is on the machine, remove
it and lock the side-discharge door; refer to
the Side-Discharge Chute (page
1.
Raise and hold up the rear door
(Figure
30).
(Figure
31).
15).
Removing
17).
(Figure
33).
g002591
1. Rear door
2.
Pull out the rear-discharge plug
Operating Tips
General Mowing Tips
•
Inspect the area where you will use the machine
g002592
and remove all objects that the machine could
throw.
•
Avoid striking solid objects with the blade. Never
deliberately mow over any object.
•
If the machine strikes an object or starts to vibrate,
immediately shut off the engine, disconnect the
wire from the spark plug, remove the electric-start
button (if equipped), and examine the machine for
damage.
•
For best performance, install a new blade before
the cutting season begins.
•
Replace the blade when necessary with a Toro
replacement blade.
Cutting Grass
•
Cut only about a third of the grass blade at a time.
g002593
Do not cut below 51 mm (2 inches) unless the
grass is sparse or it is late fall when grass growth
begins to slow down.
•
When cutting grass over 15 cm (6 inches) tall,
mow at the highest cutting height setting and walk
slower; then mow again at a lower setting for the
best lawn appearance. If the grass is too long, the
machine may plug and cause the engine to stall.
•
Wet grass and leaves tend to clump on the yard
and can cause the machine to plug or the engine
to stall. Avoid mowing in wet conditions.
•
Be aware of a potential fire hazard in very dry
conditions, follow all local fire warnings, and keep
the machine free of dry grass and leaf debris.
17
Figure 33
2. Rear-discharge plug
(Figure
g187598
33).