Rear-Discharging The Clippings; Adjusting The Blade Speed; Shutting Off The Machine; Removing The Battery Pack From The Machine - Toro 48cm 60V Super Recycler Bedienungsanleitung

Rear-Discharging the
Clippings
Use the rear discharge for cutting very tall grass.
Note:
If the grass bag is on the machine, remove
it before rear-discharging the clippings; refer
to Removing the Grass Bag (page
bag-on-demand lever should be in the
position as shown in Figure
WARNING
The blade is sharp; contacting the blade can
result in serious personal injury.
Shut off the engine and wait for all moving
parts to stop before leaving the operating
position.

Adjusting the Blade Speed

This machine has 2 blade-speed settings: A
M .
AX
•
When set to the A
UTO
is adjusted automatically for greater efficiency;
changes in cutting conditions are detected and
the blade speed increases when necessary to
maintain quality of cut.
•
When set to the M
AX
remains at the highest speed at all times.
Turn the key in the key switch to either position to
adjust the blade speed setting
Figure 17
1. A position
UTO
15). The
BAGGING
15.
UTO
position, the blade speed
position, the blade speed
(Figure 17).
2. M position
AX

Shutting Off the Machine

1. Release the blade-control bar (A of
2. Remove the electric-start button from the electric
starter (B of
3. Remove the battery pack; refer to
Battery Pack from the Machine (page
Note:
Whenever you are not using the machine,
remove the battery pack.
and
Removing the Battery Pack
from the Machine
1. Lift up the battery-compartment lid.
2. Press the battery-pack latch to release the
battery pack and remove the battery pack.
3. Close the battery-compartment lid.
g337279
16
Figure 18).
Removing the
Figure 18
Figure 18).
16).
g251435