Replacing Carbon Brushes; Optional Accessories - Makita BUH550 Bedienungsanleitung

► Fig.27
Place the new shear blades on the tool so that the oval
holes in the shear blades fit onto the crank. Overlap the
holes in the shear blades with the screw holes in the
tool and then secure them with two screws.
► Fig.28: 1. Oval hole of shear blade 2. Crank
Check the crank for smooth turn with a slotted bit
screwdriver.
► Fig.29: 1. Crank
Install the plate, under cover on the tool. Tighten the
screw firmly.
NOTE:
• There is no distinction between the top and
bottom of the plate.
Remove the blade cover and then turn on the tool to
check it for proper movement.
NOTE:
• When the shear blades does not operate prop-
erly, there is a poor fit between the blades and
crank. Redo from the beginning.

Replacing carbon brushes

► Fig.30: 1. Limit mark
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
► Fig.31: 1. Holder cap cover 2. Screwdriver
Insert the top end of slotted bit screwdriver into the
notch in the tool and remove the holder cap cover by
lifting it up.
► Fig.32: 1. Brush holder cap 2. Screwdriver
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
Reinstall the holder cap cover on the tool.
Storage
The hook hole in the bottom of the blade cover is con-
venient for hanging the tool from a nail or screw on the
wall.
► Fig.33
Remove the battery cartridge and put the blade cover
on the shear blades so that the blades are not exposed.
Store the tool out of the reach of children carefully.
Store the tool in the place not exposed to water and
rain.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized Service Centers, always
using Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
• These accessories or attachments are recom-
mended for use with your Makita tool specified
in this manual. The use of any other accessories
or attachments might present a risk of injury to
persons. Only use accessory or attachment for
its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Blade cover
• Shear blade assembly
• Makita genuine battery and charger
• Battery adapter
• Arm cord hook (to be used together with the bat-
tery adapter)
• Chip receiver
NOTE:
• Some items in the list may be included in the
tool package as standard accessories. They
may differ from country to country.
13 ENGLISH