Activating/Deactivating The Signal Tone (Beep On); Setting The Speed-Dependent Volume Increase (Auto Snd) - Blaupunkt new jersey mp68 Bedienungs- Und Einbauanleitung

User settings
In addition, you can assign a lower volume up
to the value 0 (mute) to the volume reduction
(MUTE).
u
In the System menu, press the rocker switch
@ repeatedly until one of these
or
menu items is displayed:
•
"MUTE VOL ": Presets the volume of the
volume reduction
•
"TEL VOL ": Presetting the volume of the
phone call/navigation announcement
•
"TA VOL ": Presetting the volume of the
traffi c announcement
u Press the OK button : to call up the menu
item.
The currently set volume is displayed.
u
Set the volume with the rocker switch or
@.
u Press the OK button : to select a different
function, or press the DIS•ESC button ; to
exit the menu.
Notes:
The volume preset by you will not be used,
•
if the volume currently listened to is lower
than the set mute level. The device
continues playing with the volume
listened to.
•
if the volume currently listened to is
higher than the set TEL volume. In this
case, phone calls/navigation announce-
ments are reproduced with the volume
listened to.
•
if the volume currently listened to is
higher than the set TA volume. In this
case, traffi c announcements are repro-
duced with the volume listened to.
118
Activating/deactivating the signal tone
(BEEP ON)
You can deactivate the signal tone that sounds as
a confi rmation in the menus or when storing the
stations on the station buttons.
u
in the System menu, press the rocker switch
@ repeatedly until the "BEEP ON"
or
menu item is selected.
u Press the OK button : to call up the menu
item.
u
Switch between the settings with the rocker
switch or @.
•
"BEEP ON "
•
"BEEP ON"
u Press the OK button : to select a different
function, or press the DIS•ESC button ; to
exit the menu.
Setting the speed-dependent volume
increase (AUTO SND )
When you are driving faster, the device can au-
tomatically increase the volume to compensate
for the driving noise. The volume is increased
depending upon the speed. In order for this to
work, the speedometer signal must be connect-
ed as described in the installation instructions.
The optimum setting for this volume increase de-
pends on how noise levels develop in your par-
ticular vehicle. Try the setting that is perfect for
your vehicle. You can select a value between OFF
(no increase) and 5 (maximum increase).
u
In the System menu, press the rocker switch
@ repeatedly until the "AUTO SND"
or
menu item is selected.
u Press the OK button : to call up the menu
item.
The current setting is displayed.
u
Select the desired setting with the rocker
switch or @.
: Signal tone on.
: Signal tone off.