Description; Accessories - Hilti PP10 Bedienungsanleitung

2 Description

2.1 Use of the product as directed
The tool is designed to be used for determining, transfer-
ring or checking alignment in the horizontal and inclined
planes, e.g.: transferring heights and in pipe laying work.
Hilti supplies various accessories which allow the tool to
be used with maximum efficiency.
en
2.2 PP 10/25 pipe laser
The PP 10/25 is a pipe laser featuring a visible laser beam
(spot) that can be used for alignment in the horizontal or
inclined planes.
2.3 PPA 20 remote control unit
The PPA 20 is used to switch the PP 10/25 pipe laser on
and off, to activate horizontal alignment and to select the
laser beam mode remotely.
2.4 Features
A single person working with the tool can set out any
desired inclination (within the -15% to +40% range) with
great accuracy. The tool levels itself automatically when
set up within ±10% of the horizontal plane.
2.5 Automatic cut-out
The laser beam and the LED on the control panel blink
if the tool is set up outside its self-leveling range. The
direction in which the tool requires to be tilted is also
shown in the display.
2.6 PPA 82 battery
Battery performance drops at low temperatures.
DANGER
Batteries should be stored at room temperature.
DANGER
Never store the battery where it is exposed to the
heat of the sun, on a radiator or behind glass, e.g. at
a window.

3 Accessories

PP 10 / 11 accessories
Designation
PPA 83 battery holder (size D cells)
PPA 84 connecting cable (12V)
PPA 75 height adapter
PPA 73 tripod adaptor
PPA 40 telescopic sight
16
All manuals and user guides at all-guides.com
2.7 Automatic charging cut-out
The charging operation is stopped automatically to pro-
tect the battery when the temperature exceeds the spe-
cified charging temperature range.
NOTE
Charge the battery every 3 to 4 months. Store the battery
at a maximum temperature of 30°C (86°F). Allowing the
battery to become fully discharged may have a negat-
ive effect on its future performance. Charging may take
less than 9 hours if the battery was not previously fully
discharged.
2.8 Use of various power sources
Three different power sources may be used: the standard
PPA 82 battery supplied or the PPA 83 battery holder
or PPA 84 external 12V cable which are available as
accessories.
2.9 Items supplied
1 PP 10 or 25 pipe laser (depending on version
purchased)
1 PPA 20 remote control unit
1 Target plate, short
1 Target plate, long
1 PPA 74 target plate holder
1 PPA 81 charging adaptor
1 PPA 82 battery incl. mains adaptor
1 Set of 4 screw feet, 150 mm
1 Set of 4 screw feet, 200 mm
1 Set of 4 screw feet, 250 mm
1 Set of 4 screw feet, 300 mm
1 PPA 30 centering screw
1 PP 10/25 operating instructions
4 Batteries (size AAA cells)
1 Manufacturer's certificate
1 Hilti toolbox