CombiSteel 7455.0075 Gebrauchsanweisung Seite 11

4. Insert new knife, screw on the fastening srew (pic. 4).
Pic. 4
Fasten the screw in the centre of the knife only by hand, and the screw will become fully tightened automatically
during operation.
5. Install the protector.
Pic. 5
Step 1: For installing the protector, make sure the pin in the left side is in the groove first. (pic.5)
(pic.6) (pic.7)
Step 2: Make the pin in the right side is in the groove secondly. (pic.6)
Step 3: Make sure the adjusting screw is in the groove above the protector. (pic.7)
Step 4: Finally, pull down the protector, and make sure the protector in correct position.
11
www.combisteel.com