Pushing The Wheelchair; Transporting The Wheelchair; Transporting By Car - Vermeiren Tracer Gebrauchsanweisung

L
When inflating the tyres, always check that the pressure is correct. The correct pressure is
given on the tyre walls (also refer to "Technical details").
L
Use only inflating equipment which complies with regulations and indicates the pressure in
bar, or use the supplied air pump. We do not accept any liability for damage caused by using
inflation equipment not supplied by the manufacturer.

PUSHING THE WHEELCHAIR

The wheelchair can be pushed by an attendant. Turn the locking lever outwards (inwards in the case
of the TRACER 50+); this allows the wheelchair to be pushed freely. Now the wheelchair will no longer
be driven by the motors, nor will it be braked by the motors.
1

TRANSPORTING THE WHEELCHAIR

Before lifting up the wheelchair, all moveable parts must be dismantled (footrests, armrests, and
steering unit).
L
When raising the wheelchair, it should only be grasped by fixed parts of the frame.
L
To prevent damage, the steering unit and armrests should be removed for transportation.
L
When assembling, make sure that all screws are retightened properly.
To prevent the wheelchair from moving about, switch the locking mechanism behind the backrest to
electronic driving (it must be engaged). In addition, engage the parking brakes if present in your
model. If you require further belt securing systems, make sure that they are only attached to solid
parts of the frame.
If you want to be taken up or down stairs with the wheelchair, you will need a wheelchair ramp
L
At least two persons are required to move the wheelchair up or down stairs or over single
steps.
L
When being transported, no persons or objects should be below the wheelchair, to prevent
personal injury or damage to the wheelchair.

TRANSPORTING BY CAR

When inside a vehicle the wheelchair must be securely fastened by means of the built-in safety belts
or by specially provided belt systems.
Nobody is permitted to sit in a wheelchair which is transported in a vehicle.
L
Make sure that the wheelchair is fastened by fixed parts of the frame only.
L
Check that the wheelchair cannot slide in any direction.
When pushing the wheelchair, make sure that the
controls are switched off and that you only push it on
level terrain.
When the locking lever is in this direction, e-
1
driving is enabled; the electromagnetic brake
is activated.
When the locking lever is in this direction,
your wheelchair is in the free-wheeling
position;
deactivated.
Without the braking effect of the motors which
is absent when the wheelchair is being
pushed, the wheelchair can accidentally move
or turn. (Use the parking brakes to secure the
wheelchair !).
or wheelchair lift system.
19
the electromagnetic brake
E
TRACER
01/2010
is