Interface Cards; Initial Commissioning; Unpacking; Installation And Connection - Bosch 1 687 023 850 Originalbetriebsanleitung

3.7.3

Interface cards

i
Peripheral devices operated with the PC must
support at least USB 2.0. The PC is provided with
six USB interfaces USB 3.0; these USB interfaces
can only be used for the operation of peripheral
devices which support USB 3.0.
Fig. 6: Ports
1 USB (USB 2.0)
2 Serial COM 1/COM 2
Robert Bosch GmbH
Initial commissioning | 1 687 023 850 – 858 | 15 |
4.
4.1
1. Unpack the PC.
2. Check the scope of delivery.
3. Dispose of the packaging materials in the proper
manner.
4.2
i
The PC is supplied already installed and connected
in most Robert Robert GmbH products. Proceed
as described below if a PC has to be installed
on commissioning or if an existing PC is to be
1
replaced. Otherwise this Section can be ignored.
2
1. Disconnect the PC from the power supply.
2. Remove the covers.
3. Disconnect the connecting cables from the
previous PC.
4. Remove the previous PC.
5. Fit the new PC.
6. Connect the connecting cables to the new PC.
7. Fit the covers.
Fig. 7:
i
For further information on installation in the
tester, see the fitting instructions "EPS 708"
(1 689 978 559).

Initial commissioning

Unpacking

Installation and connection

Installation position of tower in trolley
1 689 989 347
en
|
2021-04-24