Interface Cards - Bosch BEA 810 Betriebsanleitung

3.7 Connections
3.7.1 Layout
The back of the PC is divided into four sections.
3
4
Fig. 5: Connections
1 Power supply unit
2 Fan
3 Mainboard

4 Interface cards

i
The design of the mainboard connections is the
same for every type of PC (refer to Sec. 3.7.2). The
connections in the area of the interface cards de-
pend on the type of PC (refer to Sec. 3.7.3).
3.7.2 Mainboard
1 2
10 9
Fig. 6: Mainboard connections
1 Mouse (PS/2)
2 Monitor (VGA)
3 LAN (RJ45)
4 Audio (input)
5 Audio (output)
6 Microphone
7 USB (USB 3.0)
8 USB (USB 2.0)
9 Monitor (DVI)
10 Keypad (PS/2)
Robert Bosch GmbH
1
2
3 4
5
8 7 6
1 687 023 689 – 692 | 17
Network LED status (LAN)
2
1
Fig. 7: Network LED status (LAN)
1 Network access LED
2 Network transmission rate LED
LED Display
Network Off
access
Flashing green
Network Off
transmissi-
Green light
on rate
Orange light
3.7.3 Interface cards
i
Peripheral devices operated with the PC must sup-
port at least USB 2.0. The PC is provided with two
USB interfaces USB 3.0; these USB interfaces can
only be used for the operation of peripheral devices
which support USB 3.0. If use is to be made of CAN,
SVTW or VPM 844 ISO modules, these are to be
installed before fitting the PC in the trolley or tester.
For further information refer to the fitting instruc-
tions "1 687 001 949" (1 689 978 556).
!
Only devices with a fire-proof housing are to be ope-
rated from the 25-pin connection of SVTW modules.
1 687 023 689 / 1 687 023 690
Fig. 8: Connections 1 687 023 689 / 1 687 023 690
1 USB (USB 2.0)
2 Serial COM 1 / COM 2
en
Status
No link
Data being transmitted
Transmission rate 10 Mb/s
Transmission rate 100 Mb/s
Transmission rate 1000 Mb/s
1
2
|
1 689 989 190 2018-02-24