Interface Cards - Bosch 1 687 023 818 Betriebsanleitung

3.7.2 Mainboard
1 2
10 9
Fig. 4: Mainboard connections
1 Mouse (PS/2)
2 Monitor (VGA)
3 LAN (RJ45)
4 Audio (input)
5 Audio (output)
6 Microphone
7 USB (USB 3.0)
8 USB (USB 2.0)
9 Monitor (DVI)
10 Keypad (PS/2)
Network LED status (LAN)
2
1
Fig. 5: Network LED status (LAN)
1 Network access LED
2 Network transmission rate LED
LED Display
Network Off
access
Flashing green
Network Off
transmis-
Green light
sion rate
Orange light
Robert Bosch GmbH
3 4
5
8 7 6
Status
No link
Data being transmitted
Transmission rate 10 Mb/s
Transmission rate 100 Mb/s
Transmission rate 1000 Mb/s
1 687 023 818 – 822 | 17
3.7.3

Interface cards

i
Peripheral devices operated with the PC must sup-
port at least USB 2.0. The PC is provided with two
USB interfaces USB 3.0; these USB interfaces can
only be used for the operation of peripheral devices
which support USB 3.0. If use is to be made of CAN,
SVTW or VPM 844 ISO modules, these are to be
installed before fitting the PC in the trolley or tester.
For further information refer to the fitting instruc-
tions "1 687 001 949" (1 689 978 556).
!
Only devices with a fire-proof housing are to be oper-
ated from the 25-pin connection of SVTW modules.
1 687 023 818 / 1 687 023 819 / 1 687 023 821 /
1 687 023 822
Fig. 6: Connections
1 USB (USB 2.0)
2 Serial COM 1 / COM 2
1 687 023 820
Fig. 7: Connections 1 687 023 820
1 Serial COM 1 / COM 3
2 USB (USB 2.0)
3 Serial COM 2 / COM 4
en
1
2
1
2
3
|
1 689 989 326 2016-11-11