Time Setting - Respekta PYRO 9 TOUCH Bedienungs- Und Installationsanleitung

hour value 12 will flash, the clock can be set at this time, refer to clock setting requirement
for details.
All the backlights will turn on after 20s without any operation and the oven will enter function
to be selected mode.The oven will switch off if without any operation for 3 minutes,and
press any key at this time,it will return to function to be selected mode.
After the oven is energized, the oven door lock will perform self-inspection. During the self-
inspection, the door lock will automatically go back and forth once, and the door lock self-
inspection will be completed within 20 seconds. If the program automatically prompt the
error code during the oven self-inspection ,and the display shows "E-3", please refer to the
part of "protection function11.5.1~11.5.2" for the specific cause analysis. At this time, press
the power button to cancel the alarm code. The program will enter the function to be
selected state.
Function to be selected mode: The display screen will show current time,all backlights of
the buttons will be on.
Stand-by mode: The display screen will show current time,all backlighst of the buttons will
be off.
Power off mode: The display screen will be off,and all backlight of the buttons will be off as
well.
2、Time setting
2.1 Time setting after the oven is energized:First time when the oven connects to the
main supply,and PCB board completed the self-inspection, default time will show 12:00 at
this time,display screen hour value "12" will flash(1 time/S), well set the hour time by
+
touching " " or "
Pic 3: Adjusting hour
After setting hour time, use adjusting time combination button (Touching button "
at the same time) to switch to minute adjusting. Minute "00" will flash at this time, by
+
touching " "or "
After setting minutes, re-touch the combination key to confirm, time setting is completed.
When setting hour, " "will display. When setting minutes, "
confirmation, " "and"
If well set clock minutes for 10s without confirmation, the system will confirm automatically
and enter into function to be selected mode. If switch on 20s without time setting, system
time will be "12:00" by default and enter function to be selected mode. If the electricity is cut
off, clock needs to be reset.
"; (00~23~00 is recyclable)
" to set minutes（0~59~0 recyclable）.
"will not display. Press and hold "
Pic 4: Adjusting minute
+
14
+
"will display. After
"or " " to quickly setup time.
"and " "