Installing The Batteries; Installing Aaa Batteries In The Detector; Using The Accessories; Tripod Mount - Stanley STHT77616 Bedienungsanleitung

Always insert batteries correctly with regard to
polarity (+ and –), as marked on the battery and the
equipment. Do not mix old and new batteries.
Replace all batteries at the same time with new
batteries of the same brand and type.
WARNING:
Batteries can explode, or leak, and can cause injury
or fire. To reduce this risk:
• Carefully follow all instructions and warnings on the battery
label and package.
• Do not mix battery chemistries.
• Do not dispose of batteries in fire.
• Keep batteries out of reach of children.
• Remove batteries if the device will not be used for several
months.
• Do not short battery terminals.
• Do not charge disposable batteries.
• Remove dead batteries immediately and dispose of per local
codes.

Installing the Batteries

Installing D Batteries in the Laser Tool
On the bottom of the laser, lift the latch to unlock and open
1.
the battery compartment cover (Figure Ⓒ ①).
Insert two new, high-quality D cell batteries, making sure to
2.
position the - and + ends of each battery as noted inside the
battery compartment (Figure Ⓒ ②).
Push the battery compartment cover closed until it snaps in
3.
place (Figure Ⓒ ③).

Installing AAA Batteries in the Detector

On the back of the detector, lift the latch to unlock and open
1.
the battery compartment cover (Figure Ⓔ ①).
2. Insert two new, high-quality AAA batteries, making sure to
position the - and + ends of each battery as noted inside the
battery compartment (Figure Ⓔ ②).
Push the battery compartment cover closed until it snaps in
3.
place (Figure Ⓔ ③).

Using the Accessories

Tripod Mount

1. Choose a location for the tripod (Figure Ⓚ) where it will not
be disturbed.
Extend the tripod legs as required. Adjust the legs so the
2.
tripod head is approximately horizontal.
3. Position one of the laser tool's 5/8"‑11 screw holes
(Figure Ⓖ) over the tripod's 5/8"‑11 mounting screw and
tighten the mounting screw.
CAUTION: Do not leave the laser tool unattended on
a tripod without fully tightening the mounting screw.
Failing to do so may lead to the laser tool falling and
sustaining damage.
Target Card
Some laser kits include a plastic Laser Target Card (Figure Ⓛ)
to aid in locating and marking the laser beam. The target card
enhances the visibility of the laser beam as the beam crosses
over the card. The card is marked with standard and metric
scales. The laser beam passes through the red or green
plastic and reflects off the reflective tape on the reverse side.
The magnet at the top of the Target Card is designed to hold
it to ceiling tracks or steel studs to determine plumb and level
positions. For best performance when using the Target Card, the
front of the card should be facing you.
Laser Enhancement Glasses
Some laser kits include Laser En hancement Glasses
(Figure Ⓙ). These glasses improve the visibility of the laser
beam under bright light conditions or over long distances when
the laser is used for interior applications. These glasses are not
required to operate the laser.
CAUTION:
These glasses are not ANSI approved safety glasses
and should not be used while operating other tools.
These glasses do not keep the laser beam from entering
your eyes.
CAUTION:
To reduce the risk of serious injury, never stare directly
into the laser beam with or without these glasses.
GB
GB
11