Information Codes; 9-Troubleshooting - Haier HW120-B14876 Bedienungsanleitung

EN
of a problem please check all shown possibilities and follow below instructions before you
WARNING!
Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
improper repairs can cause considerable consequential damages.
A damaged power cable should only be replaced by the manufacturer, its service

9.1 Information codes

Following codes are displayed only for information referring to the washing cycle. No
measures must be performed.
Code Message
1:25
The remaining wash cycle time will be 1 hour and 25 minutes.
6:30
The remaining wash cycle time including chosen end-time delay will be 6 hours and 30 minutes.
AUtO
Automatic load detection is working; only in some programs.
End
Lock-
Door is closed because of high water level, high water temperature or spinning cycle
bEEP OFF
The buzzer is deactivated.
bEEP On
The buzzer is activated.
The function keys is closed.The programme changing is invalid.
9.2 Troubleshooting with display code
r P b o e l m C u a e s
E1
within 6 minutes.
E2
E4
E8
Fb
Water pressure switch continuously leaks
for 10 seconds-error

9-Troubleshooting

ustomer Service.
o S u l i t n o
pressure is normal.
Open drain pump to drain
Shut down the machine
.
23