C) Operation - Renkforce 2302377 Bedienungsanleitung

c) Operation

• Check the product for damages before each use, e.g. the housing and the power cord/plug.
If you find any damage, you must not use the product. Repair of a damaged power cord is not permitted!
There is danger to life through an electric shock!
If the product is already connected to the mains, switch off the mains at the respective socket (e.g. by
turning off the circuit breaker). Furthermore, turn off the residual current device in order to disconnect all
poles of the mains socket from the mains voltage.
Following this, you may remove the power plug of the product from the mains socket. The product must
no longer be used after that; take it to a specialist workshop.
Repairs should be carried out by a specialist workshop!
• If you have reason to assume that safe use is no longer possible, discontinue use of the product and
remove the power plug from the mains socket to secure it against unintentional operation. It must be
assumed that safe operation is no longer possible if:
- the pump or the power cord show visible damages,
- the product does not operate any longer,
- the product was transported or stored under unfavourable conditions,
- it was exposed to heavy loads during transport.
• Always disconnect the product from the mains socket when not in use, and before repairs, maintenance
or cleaning.
• Never remove the mains plug from the mains socket by pulling on the power cord. Always pull the plug
from the mains socket by only gripping the area provided on the side.
• Never touch the plug when your hands are damp or wet. Danger of a life-threatening electric shock!
• Do not hold onto the product by the power cord, e.g. during transport. Use the handle.
• The water to be pumped should be as clean as possible. Impurities (e.g. sand, earth, leaves etc.) cause
higher wear, thus reducing the life span of the product, and also the possibility of mechanical clogging of
the drive impeller and blockage of the intake openings.
Therefore, regular functional control of the product is absolutely essential.
• The product is not suitable for the conveyance of drinking water.
• The product is not suitable for the operation of swimming pools.
• Consequential damages, caused by malfunction or fault of the product, should be prevented by relevant
measures (e.g. by use of water level gauge, sensors, alarm devices).
• Before reaching into the water, disconnect the product from the mains socket.
• When the product is taken from a cold room to a warm room (e.g. during transport), condensation may
be produced. As a result, the plug may pose the risk of a lethal electric shock!
Therefore, always let the product get to room temperature before you use it, or connect it to the mains
voltage. This may take several hours.
• The product is only suitable for use in temperate, not tropical, climates.
• The product is splash-proof (protection type IPX4). Do not expose the product to direct water jets.
20