Herunterladen Inhalt Inhalt Diese Seite drucken

Air Filter; Service And Maintenance - Daikin FWT02CATNMV1 Installationshandbuch

Kaltwasser-ventilator luftkühler
Vorschau ausblenden Andere Handbücher für FWT02CATNMV1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 16
1.
Open the front panel.
Hold the panel at the recesses on the main unit
(2 recesses on right and left sides) and lift it until it
stops.
2.
Pull out the air filters.
Push a little upwards the tab at the center of each air
filter, then pull it down.
Note is valid for Turkey only: The lifetime of our products is ten (10) years
Service Parts
Indoor air filter
1.
2.
3.
Indoor unit
1.
2.
Avoid direct contact of any coil treatment cleaners on plastic part. This may cause plastic part to deform as a result of
chemical reaction.
1.
Open the front panel.
Hold the panel at the recesses on the main unit (2
recesses on right and left sides) and lift it until it stops.
2.
Remove the front panel.
While lifting the front panel further, slide it to the right
and pull it to the front side. The left rotating shaft is
detached. Slide the right rotating shaft to the left and
pull it to the front side to remove it.
3.
Attach the front panel.
Align the right and left rotating shafts of the front
panel with the grooves and push them all the way in.
Gently close the front panel. (Push both ends and the
center on the front panel.)
Don't touch the metal parts of the indoor unit. It may cause an injury.
When removing or attaching the front panel, support the panel securely with hand to prevent it from falling.
For cleansing, do not use hot water above 40°C, benzine, gasoline, thinner, nor other volatile oils, polishing
compound, scrubbing brushes, nor other hand stuff.
After cleaning, make sure that the front panel is securely fixed.

AIR FILTER

Recess on
main unit

SERVICE AND MAINTENANCE

Remove any dust adhering to the filter by using a vacuum cleaner or wash in lukewarm
water (below 40°C/104°F) with a neutral cleaning detergent.
Rinse the filter well and dry before placing it back onto the unit.
Do not use gasoline, volatile substances or chemicals to clean the filter.
Clean any dirt or dust on the grille or panel by wiping it with a soft cloth soaked in
lukewarm water (below 40°C/104°F) and a neutral detergent solution.
Do not use gasoline, volatile substances or chemicals to clean the indoor unit.
! CAUTION
! CAUTION
3.
Clean or replace each filter.
When shaking off remaining water, do not wring the
filter.
4.
Set the air filter as they were and close the front
panel.
Insert claws of the filters into slots of the front panel.
Close the front panel slowly and push the panel at the
3 points. (1 on each side and 1 in the middle.)
The air filter have a symmetrical form in the horizontal
direction.
FRONT
Maintenance Procedures
Rotating shaft
1-9
Recess on
main unit

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis