INSTALLATION / CONNECTION
Installing the unit (in-dash mounting)
Do the required wiring.
( 14)
Dashboard of your car
When installing without the mounting sleeve
1
Remove the mounting sleeve from the unit.
2
Align the holes in the unit (on both sides) with
the vehicle mounting bracket and secure the
unit with screws (commercially available).
Use only the specified screws. Using wrong screws might
damage the unit.
Bend the appropriate tabs to hold the mounting
sleeve firmly in place.
How to remove the unit
1
Fit the catch pin on the extraction keys into the
holes on both sides of the trim plate, then pull
it out.
2
Insert the extraction keys deeply into the slots
on each side, then follow the arrows as shown
below.
Part list for installation
(A) Mounting sleeve
(B) Trim plate
(C) Wiring harness
(D) Extraction key
13
ENGLISH