Storing Stations In Memory; Fm Station Automatic Preset: Ssm - JVC ks-fx942r Bedienungsanleitung

3
Tune in to a station you want while
"MANU" (manual) is flashing.
• If you release your finger from the button,
the manual mode will automatically turn
off after 5 seconds.
• If you hold down the button, the frequency
keeps changing (in 50 kHz intervals for
FM and 9 kHz intervals for AM—MW/LW)
until you release the button.
When an FM stereo broadcast is hard to
receive:
1
2
MO (monaural) indicator
When the MO indicator is lit on the display, the
sound you hear becomes monaural but the
reception will be improved.
10
To tune in to stations
of higher frequencies
To tune in to stations
of lower frequencies
Press MODE to enter the
functions mode while listening
to an FM stereo broadcast.
"MODE" flashes on the upper
part of the display.
Press MO (monaural), while
"MODE" is still flashing on the
display, so that the MO
indicator lights up on the
display.
Each time you press the
button, the MO indicator lights
up and goes off alternately.

Storing stations in memory

You can use one of the following two methods to
store broadcasting stations in memory.
• Automatic preset of FM stations: SSM (Strong-
station Sequential Memory)
• Manual preset of both FM and AM stations

FM station automatic preset: SSM

You can preset 6 local FM stations in each FM
band (FM1, FM2, and FM3).
1
Select the FM band (FM1 – 3) you
want to store FM stations into.
Each time you press the
button, the band changes as
follows:
FM 1 FM 2
(F1) (F2)
2
Press and hold both buttons for
more than 2 seconds.
"- -SSM- -" appears, then disappears
when automatic preset is over.
Local FM stations with the strongest signals are
searched and stored automatically in the band
number you have selected (FM1, FM2, or FM3).
These stations are preset in the number buttons
—No.1 (lowest frequency) to No.6 (highest
frequency).
When automatic preset is over, the station stored
in number button 1 will be automatically tuned in.
FM 3 A M
(F3)