Ten-Haaft Oyster Connect Bedienungs- Und Montageanleitung Seite 8

CONTENTS
1. General Information
1.1 Intended use
1.2 Safety precautions
1.3 Scope of supply
2. Installation
2.1 Installation space required for the Oyster® Connect
2.2 SIM Card
2.3 Power Supply
2.4 Mobile Operation
2.5 Connections
3. Control elements
3.1 Indoor Unit (Front)
3.2 Indoor Unit (Back)
4. Appendix
4.1 Notes on the protection of the environment
4.2 Type Approval
4.3 Available models
14
1. GENERAL INFORMATION
1.1 Intended use
15 This product has been designed for permanent installation on mobile homes or camper trailers or motor vehicles
16 of a similar type with a permissible maximum speed of 175 km/h.
17
Furthermore possible is the usage on watercrafts.
Power to the system must be supplied by a standard vehicle electric system with a rated voltage of 12/24 V DC.
When installing in caravans, no unregulated switching power supply can be used for the power supply. A swit-
18
ching power supply (so-called plug-in power supply) with a fixed output rated voltage in the range of 12V DC
19
up to 24V DC and a current rating of 1A can be used.
20
20
The product serves as a LTE router or WLAN router to provide a private network with a connection to the Internet
21
(existing LTE / WLAN access is required).
Using the equipment for any other than its intended purpose is not permissible.
When the system is connected to the on-board electric system, a suitable fuse typ. 3A must be provided for it
22
in the on-board circuit.
23
The manufacturer accepts no liability for direct or indirect damages or for consequential damages to the system
itself, to battery systems, motor vehicles or other equipment or goods resulting from installation or wiring errors.
24
Please also observe the following instructions from the manufacturer:
24
• The system must only be installed on appropriate vehicle roofs which are sufficiently strong and inherently
24
stable. Observe all relevant and approved guidelines of the automotive industry.
• The product does not require any regular maintenance. Opening housings and enclosures is not permissible.
Inspection and maintenance may only be performed by a qualified professional.
• Do not wash your mobile home or camper trailer with the mounted Oyster®Connect system in a single-bay or
drive-through car wash, and do not use a high-pressure cleaner.
• Any modification of the overall system by removing individual components or adding other components is
not permissible. The insertion of a SIM card (not included in the supply) is not affected by this. See chapter
2.2 / p.19 of these instructions!
• The Oyster® Connect system must be installed by a specialist workshop or qualified professional. If you en
counter any problems, or if you are unsure about anything, please contact the manufacturer or an authorised
service partner.
15