Vetus RimDrive RD125 Bedienungs- & Einbauanleitung Seite 26

t
ip
Use the holes 12 mm ( 15 / ") dia. to install temporarily lifting eyes.
32
MIN.
75 cm
(30")
c
aution
Apply a 'spreader' in order to avoid damage to the terminal box.
Use two angle brackets to lift the RimDrive if it is installed horizon-
tally.
Slide the rubber sleeves together with the plastic slabs and the
clamping straps halve way back over the Rimdrive.
Tighten the bolts of the clamping straps with a torque of 12 Nm (9
ft.lbf ).
Remove the temporarily support or the hoist and check if the Rim-
drive remains seated.
Apply a sealant on the inside transition to influence the flow of water
as little as possible.
n
ote
Check for possible leaks immediately the ship returns to water .
Apply a proper support under the RimDrive in case of:
≥ 250 mm (10")
- A tunnel tube length of more than 250 mm from RimDrive to hull.
- High speed or planing vessels.
26
vetus® Installation instructions thruster RIM DRIVE 250 mm
020574.06