Maintenance And Care - AL-KO EasyMow 1200 Betriebsanleitung

Startup
If the battery charge level has dropped be-
low the threshold set by the manufacturer as
a result of ageing or excessively long storage,
this means it cannot be recharged any lon-
ger. Have the battery and the monitoring elec-
tronic control unit checked by a dealer, tech-
nician or service partner, and renew it if ne-
cessary.
The battery status is shown on the display.
Check the battery status after about 3 months
by switching on the robotic lawn mower and
reading off the battery status. If necessary,
place it in the base station for charging.
In case of leakage of electrolyte must be rin-
sed with water / neutralizer. In case of contact
with eyes, so a doctor should be consulted.
The Li-ion battery contained is subject
to the requirements of hazardous sub-
stances regulations. The battery can be
transported on the road by private users
without being subject to additional requi-
rements. Only transport the battery if it
is undamaged. The battery must be pro-
tected against contact by other objects,
short circuit and inadvertent sliding. If
transported by third parties (e.g. haulage
company or transport by air) then it is ne-
cessary to comply with special require-
ments on the packaging and labelling.

MAINTENANCE AND CARE

CAUTION!
Before performing any maintenance
STOP button!
DANGER!
Danger of injury due to the cutting bla-
des!
During transport, always keep the cutting
blade plate facing away from your body.
Regularly check the robotic lawn mower and
the base station for damage
Have damaged parts and batteries replaced
or repaired by a dealer, technician or service
partner
Transport
Only carry the robotic lawn mower by its deck.
456776_a
Stop the robotic lawn mower using the [STOP
key] (3-2).
Switch off the robotic lawn mower using the
[ON/OFF key] (3-7).
DANGER!
Danger of injury due to the cutting bla-
des!
During transport, always keep the cutting
blade plate facing away from your body.
Cleaning
DANGER!
Danger of injury due to the cutting bla-
des!
During transport, always keep the cutting
blade plate facing away from your body.
1 Once a week, thoroughly clean the automatic
lawnmower with a hand brush or cloth.
Contamination can impair the function of
the machine if not removed.
2 Once a week, check the cutting blades (13-6)
for damage.
Damage to the electrical/electronic
system by incorrect cleaning!
Do not clean the automatic lawnmower
with a high-pressure cleaner or under
running water. Water penetration can
cause irreparable damage to the switch,
battery, motors and circuit boards.
Checking contacts
1 If the contact surfaces (11-1) on the automa-
tic lawnmower are contaminated, clean them
with a cloth.
Charring on the contact surfaces indica-
tes a poor charging contact.
Bend the springs on the base station
outwards (11-1).
Cleaning the chassis
1 Thoroughly clean grass catcher (13-5) and
guide (13-7) using a hand brush or a cloth.
37