Replacing The Compressor; Searching For Leaks And Regular Checks; Electrical Checks; Dehydration - Tecumseh Wintsys Installationsanleitung

■ 5.3.

Replacing the compressor

In the event of replacing an AJ² compressor, please refer to

annex 6.

■ 5.4.

Searching for leaks and regular checks

Use the appropriate equipment to empty or refill the system
(recovery machine, goggles, gloves, etc.).
A check for leaks must be carried out according to the local
regulations or at least once a year.
■ 5.5.

Electrical checks

Always check the electrical connections of screwed down
components. Tighten if necessary.
Check the following on a regular basis:
- the safety and control components,
- the condition of the electrical and refrigeration connections
(retightening, oxidation, etc.),
- the operating conditions,
- the compressor fixings on its base,
- the cowling attachments (no vibrations),
- the operation of the crankcase heater.
■ 5.6.

Dehydration

WINTSYS® units are all fitted with a soldered dehydration filter.
Choosing a dehydration filter:
When working on the refrigerant circuit, you are recommended
to replace the dehydration filter with one of similar capacity
and load loss. Check the assembly direction.
6

- WARRANTY

For all information on the unit warranty, please see the general
terms and conditions of sale.
7

- DECLARATION OF CONFORMITY

By this, we hereby declare that the WINTSYS® condensation
unit products comply with Low Voltage Directive 2014/35/EU.
Wintsys® condensing
constructed and documented as a sub-assembly compatible
with the recommendations of the Pressure Equipment
Directive 2014/68/EU and can be incorporated in an assembly.
Conformity certificates are available on request and from
www.tecumseh.com.
8

- DECLARATION OF INCORPORATION

Only professional staff are authorized to work on this unit.
12/44 - 366474_b / 08.2019
Installation Instructions |
units are evaluated, designed,
Translated from the original instructions
This product is a component designated for incorporation in a
machine within the meaning of European Directive
2006/42/EU. It is not permitted to put it into operation before
the machine in which it is incorporated is found or declared to
be in conformity with the applicable legislation. To this end,
this product is not itself subject to Directive 2006/42/EU.
In a constant effort to improve its products, TECUMSEH SALES
AND LOGISTICS S.A.S reserves the right to modify the
information contained in this document without warning.
Wintsys® and L'Unité Hermetique® are registered trademarks
of TECUMSEH EUROPE SALES AND LOGISTICS S.A.S.