Vesa Panel Disassembly; Wall Mounting - ONKRON M2S Benutzerhandbuch

VESA panel disassembly

1.
• Put VESA panel on a flat surface.
• Unscrew two lower nuts and put
them aside.
• Use key (K) from the kit.
WARNING: Do not unscrew upper nut of the panel!

2. Wall mounting

• WARNING: Check the wall's material and thickness of its finishing
layer.
• Assembly kit includes hardware suitable for mounting on concrete
wall with a plaster thickness of no more than 0.2" (5 mm) or dry
walls with wooden studs.
• Walls made of hollow brick, aerated concrete or double layered dry
walls need another mounting type that can be bought separately.
WARNING: DO NOT drill holes
in places where wiring may be
located.
4
K
VESA panel
WARNING: DO NOT drill holes
in places where water pipe may
be located.
UP