Design and function
5.2
Identification
No. Designation
1
Type plate (e. g. EA15)
2
Assembly number
3
Housing material
4
Voltage type
5.3
Principle of operation
The actuator runs by switching the voltage from the OPEN position to the CLOSE position.
By switching the voltage to the other input, the actuator runs from the CLOSE position
to the OPEN position.
The end positions are factory set to 0 and 90°. End positions can later be changed via the end
position buttons, see Chapter "Adjusting end positions".
44
/67
45 VA
No.
5
6
7
8
Designation
Duty cycle/protection rating
Nominal power
Serial number
Approvals & CE-mark
Instruction manual