Commissioning And Operation - NovoPress ACO203XL Betriebsanleitung

8

Commissioning and operation

8.1 Preparing the ACO203XL/ACO203XL BT
CAUTION!
Fingers risk being crushed if the device is operated without a press
jaw/adaptor jaw (Fig. 4)
If no press jaw/adaptor jaw is fitted, fingers could be placed in the at-risk zone. Fingers
could be crushed when the device is started.
Therefore:
–
–
CAUTION!
Fingers risk being crushed if the device is operated with the finger guard
incorrectly adjusted (Fig. 8)
If the finger guard has not been slid forwards when shorter press jaws are fitted, fingers
could be placed in the at-risk zone. Fingers could be crushed when the device is
started.
Therefore:
–
–
CAUTION!
Not locking the retaining pin (8) fully can cause damage to the device.
(Fig. 5 to 7).
If the retaining pin (8) is not fully inserted and locked, the cylinder can break during the
pressing operation.
Therefore:
–
Information!
The press device is not suitable for continuous operation. Following 30 minutes
of continuous operation, a short break of at least 15 minutes must be taken to
allow the device to cool down.
•
Do not operate the device without the press jaws.
Keep your fingers away from the at-risk zone.
Do not operate the device without having slid the finger guard forwards if shorter
press jaws have been inserted (Fig. 9).
Keep your fingers away from the at-risk zone.
Press in retaining pin (8) as far as it will go and turn 180° to the rear.
Insert and lock the press jaw/adaptor jaw in the press device as shown in
Figs. 5 to 7.
ACO203XL / ACO203XL BT
19
EN