Bering INVERBOOST PX Benutzer- Und Wartungshandbuch Seite 19

Code Name
P00 Mandatory defrosting
P03 Water pump
P07 Water temp. calibration
P08 Adjustable for P9-P11
P09 Compressor Frequency
P10 Opening degree of EEV
P11 Fan motor rotate speed
P14 Restore to factory settings
P16 Product code
P17 WIFI or Modbus
P18 Mode
Remark: Logic of filtration pump control
Option 1; P3=0 Filtration pump is related to heat pump operation to start and stop.
Filtration pump starts 60s before compressor, filtration pump start 30s and then the water flow switch detect
flow. Before the heat pump enters into Standby mode, the compressor stops first and after 5 minutes filtration
pump stops.
Mode Condition
P3=0,
Heating T1≥Tset-0.5℃,
mode last for 30
minutes
P3=0,
Cooling T1≤Tset+0.5℃
mode , last for 30
minutes
Option 2; P3=1 Filtration pump is always on, P2=0 the timer function is no active
Under condition P3=1, whenT1≥Tset+1℃(T1≥29℃) last for 3 minutes, heat pump will be in standby, while
filtration pump is always on.
Condition for the heat pump start, timer ON actives;
When the timer reaches the set time of TIMER ON, the filtration pump will start and after 5 minutes the
heat pump start. The heat pump stays in stop if the water in temperature is ≥ Tset+1℃, before the TIMER
Scope
0-1
0-1
-9~9
0~1
18~110
0~470
300~100
0~1
/
0-1
0~1
Example
1. Then it enters into
P3=0,
standby mode for 1 hour
T1≥27.5℃,
(It will not restart except
last for 30
turn it on manually.)
minutes
P3=0, 1. Then it enters into
T1≤28.5℃, standby mode for 1 hour
last for 30 (It will not restart except
minutes turn it on manually.)
Default
0: Default normal operation
0
1: Mandatory defrosting.
1:Always running;
0
0:Depends on the running of compressor
0 Default setting: 0
1: Adjustable for P9, P10, P11
0
0: Not adjustable for P9, P10, P11
50 Adjustable if P08=1
350 Adjustable if P08=1
500 Adjustable if P08=1
1: Restore to factory settings
0 0: Default (restore P00, P03, P07, P08, P09, P10,
P11 to factory setting)
/ Depend on the machine
0: Modbus
1
1: WIFI
1: Heating only
0
0: Heating/Cooling/Auto mode
Water pump working logic
- 15 -
Remark
2. After 1 hour, the filtration pump
will restart for 5 minutes. If the
T1≤27℃, the heat pump will start
to work until T1≥27.5℃ and last
for 30 minutes to go into standby
2. After 1 hour, the filtration pump
will restart for 5 minutes. If it tests
T1≥29℃, the heat pump will start
to work until T1≤28.5℃ and last
for 30 minutes to go into standby