Bering INVERBOOST PX Benutzer- Und Wartungshandbuch Seite 18

Code
d00 IPM mould temperature
d01 Inlet water temp.
d02 Outlet water temp.
d03 Ambient temp.
d04 Frequency limitation code
d05 Piping temp.
d06 Gas exhaust temperature
d07 Step of EEV
d08 Compressor running frequency
d09 Compressor current
d10 Current fan speed
d11 Error code for last time
Remark:
d4: Frequency limitation code,
1: Coil pipe temperature limit;
4: Drive Current frequency limit;
16: Drive high temperature frequency limit
7.2.7 Parameter setting
Select and press
to set.
Note: Press
and hold 15s in order to set the values
Condition
0: No frequency limit;
2: Overheating or overcooling frequency limit;
8: Drive voltage frequency limit;
to enter, press
Scope
0-120℃
-9℃～99℃
-9℃～99℃
-30℃～70℃
0,1,2,4,8,16
-30℃～70℃
0℃～C5℃ (125℃)
0～99
0～99Hz
0～30A
0-1200 (rpm)
All error code
and to choose P00-P18 value and press
of P14, P17 and P18
- 14 -
Remark
Real testing value
Real testing value
Real testing value
flash if Real value<-9
Real testing value
flash if Real value<-9
Real testing value
N*5
Real testing value
Real testing value
Real testing value
.