Bering INVERBOOST PX Benutzer- Und Wartungshandbuch Seite 134

4) Parameter checking and setting
Click Parameter , then enter the password "0757".
Parameter setting:
(1) There are 2 modes optional for water pump operation ( P03: 1: Always running; 0: Depends on the running of
compressor).
(2) Inlet water temperature calibration. (-9.0 to 9.0℃).
(3) Temperature unit: ℃ or ℉.
(4) When you want to reset to factory default setting, tips as below pop up.
5)Switch running modes
In heating or cooling mode, there are 3 running modes(Silent, Smart, Powerful) for options
While in Auto mode, its default running mode is Smart.
- 130 -