4/ Daily Care Of Your Appliance - De Dietrich DTI 1127 X Einbau- Und Gebrauchsanweisung

4 4 / / DAILY CARE OF YOUR APPLIANCE
EN
It will be easier to maintain your hob if you clean it before it has completely cooled down.
However, never clean your appliance while it is in operation. Set all the controls to zero.
➤
Maintaining
spark igniters and
injectors
➤
Maintaining
pan supports and
gas burners
➤ Maintaining the
glass top
➤ Maintaining the
induction zones
— We recommend cleaning the hob fittings by hand rather than in a dishwasher.
— Do not use an abrasive sponge to clean your hob.
— Do not use a steam cleaner.
— In the event that a crack becomes visible in the glass worktop, immediately unplug
the appliance to avoid an electric shock and contact the After-Sales Service
department.
WHAT TO DO?
Nut
Thermocouple
➡If the spark igniters become
clogged, clean them using a
small, stiff-bristled brush (non-
metallic bristles).
➡The gas injector is located in
the depression in the centre of
the burner. Be careful not to
obstruct it during cleaning, as
this will undermine
performance of your hob. Use a
safety pin to unblock the injector
if necessary.
➡ For tough stains, use a non-
abrasive cream, then rinse with
clean water. Carefully wipe each
part of the burner before using
your hob again.
➡ Clean with warm water and
then wipe. For tough stains, use
special vitroceramic
cleaning products.
➡ Clean with warm water and
then wipe. If necessary finish
with the scouring side of a
sponge then wipe. For tough
stains, use special
vitroceramic products
examples opposite)
PRODUCTS/ACCESS
Injector
Spark
igniter
✓ Small, hard-bristled brush.
the
✓ Gentle scouring cream.
✓ Cleaning sponge.
✓ Cleaning sponge.
✓ Special vitroceramic glass
glass products (e.g.:
✓ Cleaning sponge.
✓ Special glass vitroceramic
products
cleaning products from your
glass after-sales service department).
(see
66
ORIES TO USE
(you can obtain