De Dietrich DTI 1127 X Einbau- Und Gebrauchsanweisung Seite 45

2 2 / / INSTALLING YOUR APPLIANCE
Your hob should be built into the top of a
supporting cabinet. The worktop should be at
least 3 cm thick, and made of a heat-resistant
material or a material with a heat-resistant
coating.
To ensure that cooking utensils can be
handled safely, a minimum of 30 cm either
side of the hob should be kept free from any
obstructions (cabinets or walls).
If a horizontal partition is positioned under
the hob, it must be located between 100 and
150 mm from the top of the work surface. In
any event, do not store aerosol cans or
containers under
compartment that may exist under the hob.
Place your hob in the opening of the support
cabinet, carefully pulling the table towards
you.
Reposition the pan supports, burner covers
and burner heads.
Connect the hob's power cable to your
kitchen's electricity supply (see "Connecting
to the power supply" with regard to the hob).
If you wish, you can fix the hob in place using
the four mounting brackets and screws
supplied with the hob (see diagram opposite)
by attaching them to the four corners of the
housing.
You must use the holes provided for this.
T T i i g g h h t t e e n n t t h h e e s s c c r r e e w w s s u u n n t t i i l l t t h h e e f f i i x x i i n n g g b b r r a a c c k k e e t t
s s t t a a r r t t s s t t o o p p u u l l l l o o u u t t o o f f s s h h a a p p e e . .
D D o o n n o o t t u u s s e e a a p p o o w w e e r r s s c c r r e e w w d d r r i i v v e e r r .
pressure in any
45
Mounting
Worktop
brackets
Fixing
holes
EN