Connection To The Electricity Mains; Start-Up; Cleaning Internal Parts - Gastrodomus ESM160 Bedienungsanleitung

For water-cooled models, connect union (15) to a tap (7) with a water supply pipe (9).
5.3.b DRAIN (Fig. 4)
Fix the water drain pipe (10) in the housing provided on the rear of the appliance. Make sure that:
• the pipe is a hose
• the internal diameter is 22 mm, as required
• the water drain hose is not throttled at any point throughout its length
• the drain hose slopes downwards by at least 15%
For water-cooled models connect union (16) to a drain with a water drainage pipe (11).
It is advisable to drain the water straight into an open drain trap.

5.4 CONNECTION TO THE ELECTRICITY MAINS

IMPORTANT:
• the appliance must be connected to the electricity mains by professionally qualified personnel in accordance with the
Manufacturer's instructions
• before connecting the appliance to the electricity mains, make sure that the mains voltage rating corresponds to the value
indicated on the rating plate
• make sure that the appliance is connected to an efficient earthing system
• make sure that the capacity of the power supply system suits the maximum power value indicated on the rating plate of the
appliance
• if the appliance comes supplied with a plug, prepare a socket controlled by an omnipolar circuit-breaker (6 in Fig .3), with a
contact-opening gap of not less than 3 mm, that provides full disconnection under overvoltage category III conditions, in
accordance with national safety standards currently in force. This switch must be equipped with fuses, with the associated
residual current device positioned in such a way as to be readily accessible. Insert the plug into the socket controlled by the
switch
• the plug must only be replaced by professionally qualified and authorized personnel, and the new plug must comply with
current national safety standards
• if the appliance comes supplied without a plug and you wish to connect it permanently to the power supply, prepare an
omnipolar circuit-breaker, with a contact-opening gap of not less than 3 mm, that provides full disconnection under overvoltage
category III conditions, in accordance with national safety standards currently in force. This switch must be equipped with
fuses, with the associated residual current device positioned in such a way as to be readily accessible. This operation must
be carried out by a specialized technician
• make sure that you fully uncoil the power supply cable and check that it is not crushed in any way
• should the supply cable be damaged, it must be replaced by a specialized technician using a special cable available from the
Manufacturer or from the Technical Service Centres

6 START-UP

6.1 CLEANING INTERNAL PARTS

The appliance will have already been cleaned in the factory. However, you are advised to wash the internal parts again before
using the appliance. Make sure that the power supply cable is unplugged before carrying out the above cleaning operation.
See cleaning and sanitizing manual for information regarding cleaning operations.
Use ordinary washing-up liquid or a water and vinegar solution for cleaning operations; after cleaning, rinse thoroughly with cold
water and discard the ice produced during the first 30 minutes after cleaning, together with any ice present in the bin.
It is advisable to avoid using abrasive detergents or powders, since these might damage the finish.
6.2 START-UP
Once the appliance has been correctly connected to the electricity mains, water mains and water drain system, it can be started
up as follows:
a) turn on the water supply tap(s) (7 in Fig. 3)
b) insert the plug (if any) in the socket and switch on the power supply by means of the relative switch fitted during the installation
phase (6 in Fig. 3)
For appliances that are connected permanently to the electricity mains, turn on by means of the switch on the outside of the
appliance, fitted during the installation phase.
Switch on appliance by pressing the luminous switch (18 in Fig. 2).
The appliance will begin to produce ice 10 minutes after start-up. Every time the appliance is started up, the rotation sensor
will perform a preliminary check on its operation during this period.
E N
E N