General Installation - Electrolux ENL60810X Benutzerinformation

6 electrolux side by side refrigeration user manual

General Installation

When correctly installed, your refrigerator should:
• have adequate clearance to the back, sides and top
for air circulation.
• be aligned to the surrounding cupboards
• have doors that will self close from a partially open position
Compact Side by Side 610L
898mm
Side by Side 700L
1000mm
1000mm
caution
Automatic aerosol systems (such as insect conrtol) should not be
located adjacent to the product as the spray may cause long term
898mm
damage to the external plastics of the appliance.
Clearances around your refrigerator
Your Side by Side Refrigerator can be installed between
cupboards or fixtures but you must allow for the following spaces
around the cabinet.
• allow a minimum of 5 millimetres clearance on both sides (refer
to diagram 1).
• allow a minimum of 10 millimetres clearance above hinge
covers (refer to diagram 1).
allow a minimum of 50 millimetres at the back of the
•
refrigerator (refer to diagram 1).
50mm
10mm 28mm
Recommended
airspace
CABINET
• allow a 200 or 350 millimetres clearance on the hinge side of the
doors, if you place the refrigerator next to
the wall. This will make cleaning easier (refer to diagram 2).
890mm
992mm
90°
Diagram 1
DOORS
• make sure that cupboards or fixtures do not stick out further than
the refrigerator cabinet.
Freezer
Door
Diagram 2
Installation
The refrigerator should arrive with the
front rollers wound down.
We recommend that the refrigerator
be tilted backwards by about 10
to 15 millimetres, this will allow
the doors to self close providing
a consistent door seal. To do this
follow the instructions below.
90°
When you want to install your
refrigerator, take the
following steps.
1. Roll the refrigerator into it's final position.
warning
The rollers are designed for forward or backward
movement only. They are not castors. Moving the
refrigerator sideways may damage your floor and the
rollers.
2. If the refrigerator is not tilted back you can adjust the two front
rollers by adjusting the large plastic roller nut (refer page 7).
90°
You may need two people, one to adjust rollers and one to tilt
the refrigerator slightly back to take the weight of the appliance
off the front rollers.
This will increase or decrease the height of the rollers. One
turn of the nut will change the tilt of the refrigerator by
approximately 10mm.
3. If the cabinet is level, then the side walls should be plumb
or vertical. If the cabinet is built in or partly built in check the
alignment of the cabinet side against the cupboard.
4. If the appliance now rocks from one corner to the opposite
rear corner, this means that the floor is uneven; you will need
to put some packing under one of the rear rollers.
5. You may now need to fine-tune the installation by adjusting the
front rollers once again.
CABINET
Note: Doors are designed
to sit proud of cabinetry
(not flush). The clearances
Fridge
shown above are the
Door
recommended minimum
clearances.
Height adjustable
front rollers
aligned to cupboard –
even gap
Top of refrigerator
is level – horizontal
Adjust front rollers for
unevenness of floor.
eg. adjust this roller down.
Packing may be required
underneath the rear roller
to ensure stability.
10-15mm
Fixed rear
rollers