Electrolux ENL60810X Benutzerinformation Seite 13

Telescopic freezer bins and crispers
For large side by sides with telescopic freezer bins and crispers
you can replace the drawer as follows:
1. Push the telescopic slides in all the way.
2. Slide the drawer into place over the slides and push the bin in
until it stops. The bin will not be closed all the way.
3. Open the bin to access the finger tabs at the ends of the
telescopic slides, on each side of the bin. Using your thumb
and forefinger, lift the bin over the end of the slide and clip
in place. If the drawer is not fully engaged on the slide, it's
possible the drawer won't stay on the slide if fully extended.
The end of slide must
be clipped into place
4. Fully close the bin.
When replacing the drawers after cleaning, we recommend fitting
the lower drawer first.
Freezer baskets
Wire baskets are used in the compact side by side model. All the
baskets pull out for easy access and have a stop to prevent the
basket being pulled out too far.
To remove the basket, pull it out until it hits the stop then lift
the front to unhook the stop while continuing to pull forward,
until the basket is free of the runners under the shelf.
Deodoriser
Your appliance is fitted with a deodoriser to assist with the removal
of food odours inside your appliance. (Refer pages 4 and 5 item 14).
Odours are removed by absorption through the filter by the normal
operation of the appliance. Keeping food covered and wrapping
food with plastic wrap will also help to reduce the odours inside
your appliance.
deodoriser
electrolux side by side refrigeration user manual 13
Slide away glass shelf
This shelf can be used either as a full depth shelf or when tall items
need to be stored at the front of the appliance it can be collapsed
to half its original depth.
• To collapse the shelf:
1. To release the front half of the shelf, pull the front section of the
shelf forward whilst pushing the rear edge of the front section up.
2. Pull the shelf forward and allow the rear to drop into the side
channels.
hook detail
3. Push the front shelf backwards until it reaches the rear stops.
• Repositioning:
To reposition shelf, pull forward until shelf reach stops.
Lift shelf clear of stops and continue to pull forwards. Once the
shelf is clear of the cabinet it can be repositioned onto any of the
other runners.