Electrolux ENL60810X Benutzerinformation Seite 7

Adjusting door alignment
Each door is independently adjustable in the vertical direction by
turning the adjustable bolts under the hinges using the spanner
provided.
Large plastic roller nut
The doors can be adjusted up or down. Depending on the amount
of adjustment required it may be sufficient to adjust only one door.
(see Diagrams below)
Note: When the height of the rollers and adjusting bolts
are correctly adjusted the refrigerator will stand firmly on
the floor and the doors will be in line with one another.
Spanner
Internal packaging
Please remove any internal packaging material before use.
There may be a strip of foam taped to the door bins. There
will also be tape applied to several parts such as the locker.
There may be a sheet of protective film attached to the
multi-flow duct at the rear of the refrigerator section, please
remove this prior to operation as it may obstruct airflow.
Protective film may also be on the display fitted to the
control housing.
Please remove all internal packaging before use. Any glue or
tape residue or the like should be removed with a solution of mild
detergent and water.
Door bins
model 610L side by side shown
Adjusting Bolt
Front Roller
Spanner
Multi-flow duct Door bins
electrolux side by side refrigeration user manual 7
Ice and water models
The water connection to your ice and water product should
only be done by a licensed refrigeration mechanic, plumber or
electrician. All relevant information regarding the water connection
is detailed in the water kit provided with your product for use by
the professional installer only.
The automatic ice and water dispenser needs a drinkable water
supply with a pressure of:
• minimum 206 kPa (30 psi, 2.11 kgf/cm2)
• maximum 689 kPa (100 psi, 7.04 kgf/cm2)
In some areas water pressure is significantly higher due to local
conditions. In such areas a pressure reducing valve must be used.
Ensure your plumber or installer checks your local water pressure
when installing your refrigerator.
If you are using your refrigerator for the first time, or if you have not
used the dispenser for some time:
• discard the first seven or eight cups of water
• discard any ice that the ice maker produces in the
first 24 hours (contaminants could have settled in the water
pipes)
(see page 14 for more information)
The water tap can be anywhere and there is no limit to the amount
of pipe between the tap and the refrigerator, however some points
to note are:
1. It is better to have the tap accessible without having to roll
the refrigerator forward, so we recommend putting it outside
the cavity as shown by the taps in the diagram below.
2. It is recommended, but not essential that the height
of the tap should be 400mm from the ground.
3. If the refrigerator is required to be pulled forward for cleaning,
the water pipe may need to be removed from the tap.