Symbols On The Product; Product Liability - Husqvarna 525LK Bedienungsanweisung

5. Shaft
6. Loop handle
7. Throttle trigger
8. Stop switch
9. Throttle trigger lockout
10. Spark plug cap and spark plug
11. Shaft coupling
12. Cylinder cover
13. Starter rope handle
14. Fuel tank
15. Air filter cover
16. Air purge bulb
17. Choke control
18. Handle adjustment
19. Drive disc
20. Operator's manual
21. Hex key
22. Locking pin
23. Combination wrench

Symbols on the product

WARNING! Be careful and use the
product correctly. This product can cause
serious injury or death to the operator or
others.
Read the operator's manual carefully and
make sure that you understand the
instructions before you use this product.
Use a protective helmet in locations where
objects can fall on you. Use approved
hearing protection. Use approved eye
protection.
Use approved protective gloves.
Use heavy-duty slip-resistant boots.
The product can cause objects to eject,
which can cause injury.
Maximum speed of the output shaft.
Keep a minimum of 15 m distance to
persons and animals during operation of
the product.
1027 - 001 - 23.04.2019
Only use flexible cutting wire. Do not use
metal cutting equipment for grass
trimming.
The arrows show the limit for the handle
position.
Air purge bulb.
Choke.
Fuel.
Noise emission to the environment
complies with applicable EC Directives.
The noise emission of the product is
specified in [xref] and on the label.
The product agrees with the applicable
EC directives.
yyyywwxxxx
Note:
Other symbols/decals on the product refer to
certification requirements for some markets.
EU V
WARNING:
voids the EU type-approval of this product.

Product liability

As referred to in the product liability laws, we are not
liable for damages that our product causes if:
• the product is incorrectly repaired.
• the product is repaired with parts that are not from
the manufacturer or not approved by the
manufacturer.
• the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
The rating plate shows the
serial number. yyyy is the
production year, ww is the
production week.
Tampering with the engine
3