Parameter Setting - Airwell Wellea Mono & Split R32 Bedienungsanleitung

2）Parameter setting
Register Description
address
Home appliance type
200 (PLC:40201)
201 (PLC: 40202)
Temperature upper limit of T1S cooling
202 (PLC: 40203)
Temperature lower limit of T1S cooling
203 (PLC: 40204)
Temperature upper limit of T1S heating
204 (PLC: 40205)
Temperature lower limit of T1S heating
205 (PLC: 40206)
Temperature upper limit of TS setting
206 (PLC: 40207)
Temperature lower limit of TS setting
207 (PLC: 40208)
Temperature upper limit of water heating
208 (PLC: 40209)
Temperature lower limit of water heating
209 (PLC: 40210) PUMP RUNNING TIME

Parameter setting 1

210 (PLC: 40211)
Remarks
The upper 8 bit is the home appliance type:
Central heating: 0x07
DHW PUMP water return running time. It is five minutes by default
and can be adjusted between 5 and 120 min at an interval of 1 min.
BIT15 Enable water heating
BIT14
Supports water tank electric heater TBH(Read-only)
BIT13
Supports disinfection
BIT12 DHW PUMP, 1: supported; 0: not supported
BIT11 Reserved
BIT10 DHW pump supports Pipe Disinfect
BIT9 Enable cooling
BIT8
T1S cooling high/low temperature settings(Read-only)
BIT7
Enable heating
BIT6: T1S heating high/low temperature settings(Read-only)
BIT5: Supports T1 sensor
BIT4: Supports room temperature Sensor Ta
BIT3: Supports room thermostat
BIT2: Room thermostat
BIT1: Dual Room Thermostat, 0: not supported;
1: supported
0: room cooling/heating first, 1: water heating first
BIT0:
44