Safety Warning; Assembly; Required Tools - Bosch Rexroth BT356 Bedienungsanleitung

28/124 Bosch Rexroth AG

Safety warning

A safety warning is printed next to the label
area. It warns against the high electrical
voltages in the card rack during operation
and provides maintenance information (see
"Disassembly and replacement" on page 38).
Transport and storage
For storing and transporting the product,
always observe the ambient conditions
specified in the technical data (see
"Technical data" on page 41).
When transporting BT356 card racks
installed in control cabinets or other
housings, transport safety devices must be
used depending on the position of transport.
5

Assembly

Always observe the ambient conditions
specified in the technical data (see
"Technical data" on page 41) during
installation.

Required tools

• Screwdriver
BT356 | 3 609 929 B68/2008-11
Assembling the BT356 card rack
CAUTION
Risk of damage to persons
and property!
Assembly of the BT356 card rack
requires basic mechanical and
electrical knowledge.
y Only qualified personnel (see
"Personnel qualifications" on
page 24) are authorized to
assemble the BT356 card
rack.
y Measures to prevent
electrostatic discharge (ESD
protection) must be
undertaken to protect the
module and system
components during all
assembly work.
y Observe the local, system-
specific regulations and
requirements; proper use of
tools, lifting, and transport
equipment; as well as the
relevant standards, provisions,
and accident prevention
regulations.
i
NOTE!
The protective class for the rear of the card
rack is IP20.