Herunterladen Inhalt Inhalt Diese Seite drucken

Technical Data - Makita ELM4610 Original Bedienungsanleitung

Elektrischer rasenmäher
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 12
or damaged. Replace worn or damaged blades and
bolts in sets to preserve balance.
8) Mow only in daylight or in good artificial light.
9) Avoid operating the equipment in wet grass, where
feasible.
10) Always be sure of your footing on slopes.
11) Walk, never run.
12) For wheeled rotary machines, mow across the face of
slopes, never up and down.
13) Exercise extreme caution when changing direction on
slopes.
14) Do not mow excessively steep slopes.
15) Use extreme caution when reversing or pulling the
lawn mower towards you.
16) Stop the blade if the lawn mower has to be tilted for
transportation when crossing surfaces other than
grass, and when transporting the lawn mower to and
from the area to be mowed.
17) Never operate the lawn mower with defective guards,
or without safety devices, for example deflectors and/
or grass catchers, in place.
18) Start or switch on the motor carefully according to
instructions and with feet well away from the blades.
19) Do not tilt the lawn mower when starting switching on
the motor, except if the lawn mower has to be tilted for
starting. In this case, do not tilt it more than absolutely
necessary and lift only the part which is away from the
operator.
20) Do not start the motor when standing in front of the
discharge chute.
21) Do not put hands or feet near or under rotating parts.
Keep clear of the discharge opening at all times.
22) Never pick up or carry a lawn mower while the motor
is running.
23) Stop the motor and disconnect the plug:
-
before clearing blockages or unclogging chute;
-
before checking, cleaning or working on the lawn
mower;
-
after striking a foreign object. Inspect the lawn mower
for damage and make repairs before restarting and
operating the lawn mower;
-
if lawn mower starts to vibrate abnormally (check
immediately).
24) Keep all nuts, blots and screws tight to be sure the
equipment is in safe working condition.

4. TECHNICAL DATA

Model:
Rated Voltage:
Rated Frequency:
Rated Power:
No Load Speed:
Cutting Width:
Noise according to EN60335
Sound pressure level (L
Sound power level (L
Uncertainty (K):
Vibration according to EN60335
Vibration emission (a
Uncertainty (K):
8
):
pA
):
wA
):
h
25) Check the grass catcher frequently for wear or
deterioration.
26) Replace worn or damaged parts for safety.
27) No to use the lawn mower if the cords are damaged or
worn.
28) Not to connect a damaged cord to the supply or touch
a damaged cord before it is disconnected from the
supply. A damaged cord can lead to contact with live
parts.
29) Not to touch the blade before the machine is
disconnected form the supply and the blade have
come to a complete stop.
30) To keep extension cords away from the blade. The
blade can cause damage to the cords and lead to
contact with live parts.
31) To disconnect the supply (i.e. pulling the plug from the
socket):
-
whenever leaving the machine unattended;
-
before clearing a blockage;
-
before checking, cleaning or working on the machine -
after striking a foreign object;
-
whenever the machine starts vibrating abnormally.
32) Children should be supervised to ensure that they do
not play with the appliance.
33) This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
34) If the supply cord is damaged, it must be replaced by a
special cord or assembly available from the
manufacturer or its service agent.
35) Instructions for the safe operation of the appliance,
including a recommendation that the appliance should
be supplied via a Residual Current Device (RCD) with
a tripping current of not more than 30 mA.
36) Only use the lawn mower for the purpose for which it
is designed, for cutting and collecting grass. Any other
use can be hazardous, causing damage to the
machine.
3. PARTS DESCRIPTION (Fig. 1)
ELM4610
230 V~
50 Hz
1,800 W
2,900/min
460 mm
87 dB (A)
93.3 dB (A)
2.40 dB (A)
2
2.5 m/s
or less
2
1.5 m/s
ELM4611
230 V~
50 Hz
1,800 W
2,900/min
460 mm
87 dB (A)
93.3 dB (A)
2.40 dB (A)
2
2.5 m/s
or less
2
1.5 m/s

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Elm4611Elm4612

Inhaltsverzeichnis