System Requirement For Web Browser; General Performance Considerations - Eneo NXD-2012PTZ1080 B Schnellinstallationsanleitung

• Using the Reset button:
Follow the instructions below to reset the network camera to the factory default settings
using the Reset button.
1. Switch off the network camera by disconnecting the power adapter.
2. Open the Micro-SD card cover.
3. Press and hold the Reset button (SW1) on the board with your finger while recon-
necting the power. Refer to Figure 4 - Layout of DIP switch & Reset button.
4. Keep the Reset button (SW1) pressed for about 2 seconds.
5. Release the Reset button (SW1).
6. The network camera resets to factory defaults and restarts after completing the
factory reset.
7. Tightly close the Micro-SD card cover to ensure waterproofness.
CAUTION: When performing a Factory Reset, you will lose any settings that have been
saved. (Default IP 192.168.1.10)

System Requirement for Web Browser

• Operating System: Microsoft Windows OS Series
• CPU: Intel Core 2 Duo 2Ghz or higher, 1GB RAM or more, 10GB free disk or higher
• VGA: AGP, Video RAM 32MB or higher (1024x768, 24bpp or higher)

General Performance Considerations

When setting up your system, it is important to consider how various settings and situa-
tions will affect performance. Some factors affect the amount of bandwidth (the bit rate)
36
Reset Button
Micro-SD Card Slot