Installing The Pump - Grundfos UNOLIFT Serie Montage- Und Betriebsanleitung

3.12 Installing the pump

Pumps with float switches
Adjust the cable length of the float switch before you
install the pump. See section
levels with float switches.
1. Remove the plug from the pump cable. You may
need to cut the cable.
2. SEG: Fit the foot extensions. See fig. 8.
3. Position the pump in the tank.
Make sure that the float switch, if any, can move
freely.
Unilift CC, KP, APB:
Position the pump between the three positioning
dots at the bottom of the tank so that it stays in
place during operation. See figures
SEG: The pump weight ensures that the pump
stays in place.
4. Lead the pump cable through the cable gland of
the tank.
5. Tighten the cable gland.
Fig. 8 Fitting the foot extensions on the SEG
pump
Fig. 9 Correct position of Unilift CC and KP
pumps
12
7.1.2 Setting the start
9 and 10.
Fig. 10 Correct position of Unilift APB pumps