Plasmacluster Ion On/Off; Adjustment Of Sensor Detection Sensitivity - Sharp FP-J40EU Bedienungsanleitung

LIGHT CONTROL
You can set the Cleanliness Monitor / Plasmacluster Ion Light to OFF when they are lighting up.
(with the main unit ON)
1
more than 3 sec.
2

PLASMACLUSTER ION ON/OFF

When Plasmacluster Ion is ON, the Plasmacluster Ion Light will turn on. (blue)
(with the main unit ON)
ON
more than 3 sec.

ADJUSTMENT OF SENSOR DETECTION SENSITIVITY

You can change the sensitivity of the Dust sensor / Odour sensor and the Light sensor .
1
(with the main unit OFF)
more than 3 sec.
2
Dust sensor / Odour sensor
3
DIM
AUTO
OFF
Standard High Low
NOTE
• If the power OFF Button is not pushed within 8 seconds of adjusting sensor
sensitivity, the setting will be saved automatically.
• The sensor sensitivity setting will be saved even if the main unit is unplugged.
NOTE
• If the CLEAN ION SHOWER Button is not pushed
within 8 seconds, the setting will be saved
automatically.
• When the main unit starts operation, the operation
starts in the previous mode it was operated in.
AUTO
Light automatically switches ON or DIM based on
room brightness.
Room is bright: light is ON
OFF
Room is dark: light is DIM
OFF
When set to "OFF", the "DIM" light illuminates for
8 seconds after operation starts and then the light
turns off.
NOTE
• When the main unit starts operation, the
operation starts in the previous mode it
was operated in.
more than 3 sec.
Light sensor
EN-7
4h 8h 2h
High Low
Standard