Troubleshooting - Scheppach SD1600V Originalbetriebsanweisung

GB

12. Troubleshooting

Warning: In the interests of operational safety, always switch off the saw and remove the mains plug before car-
rying out maintenance work.
Fault Possible causes
Saw blades break Tension incorrectly set
Load to great
Incorrect saw blade variety
Workpiece not fed straight
Motor does not func- Mains Gable faulty
tion
Motor faulty
Vibration Saw incorrectely installed
NOTE: The saw
vibrates slightly when
Unsuitable underlay
the motor is running
in normal operation.
The work bench is not screwed
down or is on the motor
Saw blade swings out Holders not aligned
Holders not aligned
straight
26 / 44 26 / 44
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Action
Set the correct tension
Feed the workpiece more slowly
Use the correct saw blades
Avoid exerting pressure from the side
Change faulty parts
Call customer service. Do not attempt to repair the motor
yourself as this should be carried out by trained person-
nel.
Refer to the instructions given earlier in this manual for
information on installing the saw
The heavier the work bench is,the less the vibration. A
bench made from ply wood always vibrates more than
one made from solid wood. Select the work bench best
suited to your working conditions
Tighten the locking lever (Fig. 2/Item12)
Losen the screws with which the holders are fastenedto
the arm. Align the holders so that they are perpendicular
to each other and retighten the screws.