Klarstein METROBREEZE 9 PARIS Bedienungsanleitung Seite 31

Clean the filter screen
If the filter screen is clogged with dust, and the effectiveness of the air
conditioning is reduced, be sure to clean the filter screen once every two weeks.
Clean the upper filter screen frame
1. Clasp the wedging block of
the EVA filter screen frame
with hands. Force down from
the outside to remove the EVA
filter screen frame. Unscrew
four screws fixing the EVA filter
screen and the rear housing to
remove the EVA filter screen (as
shown in the above figure) .
2. Put the EVA filter screen into
warm water with neutral
detergent (about 40 ℃ / 104
℉) and dry it in the shade after
rinsing clean.
Clean the lower filter screen frame
1. Hold the handle of the CON
filter screen frame, and pull it
outward gently to remove it.
2. Put the CON filter screen into warm water with neutral detergent (about 40 ℃
/ 104 ℉) and dry it in the shade after rinsing clean.
Postseason Storage
1. Unscrew the drainage cover, unplug the water plug, and discharge the
water in the water pan into other water containers or directly tilt the body to
discharge the water into other containers.
2. Turn on the machine, adjust it to low-wind ventilation mode, and maintain this
state until the drainage pipe becomes dry, so as to keep the inside of the body
in a dry state and prevent it from mildewing.
3. Turn off the machine, unplug the power plug, and wrap the power cord
around the wrapping post; install the water plug and the drainage cover.
4. Remove the exhaust pipe and keep it properly.
5. Cover the air conditioning with a plastic bag. Put the air conditioning in a dry
place, keep it out of the reach of children, and take dust control measures.
6. Remove batteries of the remote control and keep them properly.
7. Note: ensure that the body is placed in a dry place and keep all machine
components properly.
1 Retaining screw
2 Wedging block
3 Wedging block
1
2
3
EN
31