Klarstein METROBREEZE 9 PARIS Bedienungsanleitung Seite 21

• To avoid the risk of fire, do not cover the unit.
• All fan connections must comply with local electrical safety regulations. If
necessary, refer to these regulations.
• Supervise children so that they do not play with the unit.
• If the power cord is damaged, it must be replaced by the manufacturer,
customer service or a similarly qualified person to avoid danger.
• This equipment may be used by children over the age of 8 and by persons
(including children) with limited physical, sensory or mental capabilities and/
or lack of experience and knowledge, provided they have been instructed
in the use of this equipment by a person responsible for their safety and
understand the hazards associated with the use of this equipment. Cleaning
and maintenance of the appliance may only be carried out by children under
supervision.
• The appliance must be installed in accordance with national wiring
regulations.
• Type and voltage of fuses: T, 250 V AC, 2 A or higher.
• Contact customer service for cleaning and maintenance.
• Do not pull the power cord, deform or modify it, or immerse it in water.
Incorrect handling of the power cord may result in damage to the equipment
and/or electric shock.
• National gas regulations must be observed.
• Do not block the ventilation openings.
• Do not operate the appliance solely by inserting or removing the power plug,
as this may result in electric shock or fire due to heat.
• Immediately unplug the appliance from the wall outlet if it emits strange
noises, odours or smoke.
Instructions for handling damage
• In case of damage to the device, contact the manufacturer, customer service
or a similarly qualified person.
• If damage occurs, turn off the power, unplug the power cord, and contact the
manufacturer, the service representative, or a similarly qualified person.
• The power cord must be securely earthed.
• If the power cord is damaged, turn off the power to avoid danger and unplug
the power cord from the wall outlet. The power cord must be replaced by the
manufacturer, customer service or a similarly qualified person.
WARNING
Risk of injury! Repairs to the coolant circuit may only be carried out by trained
specialist personnel. Never attempt to repair the unit yourself!
EN
21