Replacing Air Filter; Changing Drive Belt - Comprag A-Serie Bedienungsanleitung

5.5

Replacing air filter

Fig. 5.5 Air filter replacing
5.6

Changing drive belt

1
Fig. 5.6 Changing drive belt
Open the front and right side panel, loosen the 4 screws (3) securing the bracket of the air
end by turning them 2 revolutions. Loosen the 2 bolts of the support (2) and the 2 corre-
sponding nuts (1) on the tensioner using a wrench. Remove the old belts from the pulleys
and install the new belts. After installing the new belt, tighten the belt with the appropriate
tensile force (see section 5.3 Checking Drive Belt). Tighten the 2 bolts of the support (2)
COMPRAG Screw air compressor A-Series
The air filter (1) is attached to the com-
pressor's intake valve.
In order to replace it, open the front side
panel, loosen the clamp (2) securing the
filter. Remove the contaminated filter, and
detach the clamp from it.
Set the new filter in its place and fit into
place with the clamp.
1
2
3
2
27