Comprag A-Serie Bedienungsanleitung Seite 22

1. Immediate Stop Shutdown Errors
1.1 Digital input errors
Er:0010 E
Er:0080 E
1.2 Analogue input errors
Er:0115 E
Er:0119 E
Er:0125 E
Er:0129 E
1.3 Special function errors
Er:0821 E
analogue input or digital input (incorrect connection, cable fault or sensor fault)
Er:0846 E
to be applied
2. Controlled Stop Shutdown Errors
None
3. Alarms
3.1 Digital input alarms
3.2 Analogue input alarms
Er:2118 A
Er:2128 A
3.3 Special function alarms
Er:2816 A
4. Start Inhibits
none
5. Run Inhibits
Er:3123 R
controller will allow motor start when temperature increases above the set level
6. Service Alarms
6.1 Special function service alarms
Er:4804 A
timer)
22
Emergency stop / phase failure relay
Main motor fault / ventilator motor fault
Delivery pressure sensor fault
Delivery pressure high
Delivery temperature sensor fault
Delivery temperature high
Low resistance, short circuit or short circuit to earth condition exists on an
Delivery pressure sensor range is set too low for default pressure settings
Delivery pressure high
Delivery temperature high
Power failure occurred while compressor was in the Started state
Delivery temperature Td below the set low temperature run inhibit level,
Service hours time expired, service due (reset service hours countdown
Version 4.5