materials. Store your product on flat; secure surfaces so it's not prone to falling. Store your product in a dry location. The storage temperature is -30ºC - 60ºC

(average temperature). Never exceed 80ºC under any condition. Compatibility. The product is only compatible with 6-volt, 12-volt and 24-volt Lead-Acid,

AGM, and 6-volt, 12-volt and 24-volt Lithium batteries. Do not attempt to use product with any other type of battery. Charging other battery chemistries may

result in injury, death or property damage. Contact the battery manufacturer prior to attempting to charge the battery. Do not charge a battery if you are unsure

of the battery's specific chemistry or voltage. Medical Devices. Product may emit electromagnetic fields. Product contains magnetic components which

may interfere with pacemakers, defibrilators, or other medical devises. These electromagnetic fields may interfere with pacemakers or other medical devices.

Consult with your physician prior to use if you have any medical device including pacemakers. If you suspect the product is interfering with a medical device,

stop using the product immediately and consult your physician. Cleaning. Power off the product before attempting any maintenance or cleaning. Clean and

dry product immediately if it comes in contact with liquid or any type of contaminant. Use a soft, lint-free (microfiber) cloth. Avoid getting moisture in openings.

Explosive Atmospheres. Obey all signs and instructions. Do not operate product in any area with a potentially explosive atmosphere, including fueling areas

or areas which contain chemicals or particles such as grain, dust or metal powders. High-Consequence Activities. This product is not intended for use

where the failure of the product could lead to injury, death or severe environmental damage. Radio Frequency Interference. Product is designed, tested,

and manufactured to comply with regulations governing radio frequency emissions. Such emissions from the product can negatively affect the operation of

other electronic equipment, causing them to malfunction. Model Number: GENIUSPRO50 This device complies with Part 15 of the FCC Rules. Operation

is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is

operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance

with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause

harmful interference in which case the user will be required to correct the interference at his own expense.

How To Use

Charging Modes.

The GENIUSPRO50 has seventeen (17) modes: Standby, 12V, 12V AGM, 12V LITHIUM, 6V, 6V AGM, 6V LITHIUM, 24V, 24V AGM, 24V LITHIUM, 6V

REPAIR, 12V REPAIR, 24V REPAIR, 12V SUPPLY, 24V SUPPLY, 10A Mode and Force Mode. Some charge modes must be pressed and held for three (3)

to five (5) seconds to enter the mode. These "Press and Hold" modes are advanced charging modes that require your full attention before selecting. It is

important to understand the differences and purpose of each charge mode. Do not operate the charger until you confirm the appropriate charge mode

for your battery. Below is a brief description:

Inhaltsverzeichnis