Troubleshooting - HIKOKI GM 13Y Bedienungsanleitung

English
Continuous operation
I
Switching on: Switch the machine on as described
above. Now slide the trigger switch (16)
forwards again and release in the front
position to lock the trigger switch (16)
(continuous operation).
Switching off: Push the trigger switch (16)
upwards and release.
Cleaning, Maintenance
Motor cleaning: The machine must be vacuumed
regularly, frequently and thoroughly through the
ventilation slots using a suitable vacuum cleaner.
The machine must be held firmly in this case.
Replacing the spring-mounted ring brush:
Replace worn brushes for optimal dust extraction.
Replacement brush set: Order No. 377100

Troubleshooting

Machines with VTC and TC electronics: (Fig. 3)
The electronic signal display lights up
and the load speed decreases. (17) There
is too much load on the machine! Run the
machine in idling until the electronics signal
indicator switches off.
The machine does not start. The
electronic signal display (17) flashes. The
restart protection is active. If the mains plug is
inserted with the machine switched on, or if the
power supply is restored following an interruption,
the machine does not start up. Switch the machine
off and on again.
Accessories
Use only genuine HiKOKI accessories. See
page 162.
Use only accessories that fulfil the requirements
and specifications listed in these operating instruc-
tions.
HiKOKI diamond cup wheels
Repairs
Replacing supply cord
If the replacement of the supply cord is necessary,
it has to be done by HiKOKI Authorized Service
Center to avoid a safety hazard.
Caution! In the operation and maintenance of
power tools, the safety regulations and
standards prescribed in each country must be
observed.
8
16
0
Environmental Protection
The sanding dust generated may contain
hazardous materials: do not dispose of this dust
with household waste, but at a special collection
point for hazardous waste.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
To protect the environment, do not dispose of
power tools with household waste. Observe
national regulations on separated collection
and recycling of disused machines, packaging and
accessories.
GUARANTEE
We guarantee HiKOKI Power Tools in accordance
with statutory/country specific regulation. This
guarantee does not cover defects or damage due
to misuse, abuse, or normal wear and tear. In case
of complaint, please send the Power Tool,
undismantled, with the GUARANTEE
CERTIFICATE found at the end of this Handling
instruction, to a HiKOKI Authorized Service
Center.